Chrysler 2005 Crossfire SRT6 Service Manual page 357

ZH
1120-LEFT REAR WHEEL SPEED SENSOR CIRCUIT (CONTINUED)
9.
MEASURE THE RESISTANCE OF THE LEFT REAR WHEEL SPEED SENSOR SIGNAL CIRCUIT
With the ignition off.
Measure the resistance between ground and the Left Rear Wheel
Speed Sensor Signal circuit.
Is the resistance greater than 300 ohms?
Yes >> Go to 10
No >> Replace the Left Rear Wheel Speed Sensor. (Refer to 5 -
BRAKES/ELECTRICAL/REAR WHEEL SPEED SENSOR -
REMOVAL).
Perform ABS VERIFICATION TEST.
10.
MEASURE THE RESISTANCE OF THE LEFT REAR WHEEL SPEED SENSOR SIGNAL CIRCUIT
With the ignition off.
Disconnect the CAB harness connector.
Note: Check connectors - Clean/repair as necessary.
Measure the resistance of the Left Rear Wheel Speed Sensor Signal
circuit from the CAB harness connector to the Left Rear Wheel Speed
Sensor harness connector.
Is the resistance below 5.0 ohms?
Yes >> Go to 12
No >> Repair the Left Rear Wheel Speed Sensor Signal circuit
for an open.
Perform ABS VERIFICATION TEST.
BRAKES - ABS ELECTRICAL DIAGNOSTICS 5 - 191