Online Insertion And Removal; Rpm Online Insertion And Removal; Linecard Online Insertion And Removal - Dell S4820T Configuration Manual

Online Insertion and Removal

You can add, replace, or remove chassis components while the chassis is operating.
This section contains the following sub-sections:
•

RPM Online Insertion and Removal

•

Linecard Online Insertion and Removal

RPM Online Insertion and Removal
Dell Networking systems are functional with only one RPM.
If you insert a second RPM, it comes online as the standby RPM.
To see SFM status information, use the show sfm all command.
Example of the show rpm all Command
Dell#show rpm all
-- Route Processor Modules --
Slot Status NxtBoot
-----------------------------------------------------------
0 active online
1 not present
%RPM0-P:CP %POLLMGR-2-ALT_RPM_STATE: Alternate RPM is present
%RPM0-P:CP %IRC-6-IRC_COMMUP: Link to peer RPM is up
%RPM1-S:CP %RAM-5-RPM_STATE: RPM1 is in Standby State
Dell#show rpm all
-- Route Processor Modules --
Slot Status NxtBoot
-------------------------------------------------------------
0 active online
1 standby online
Linecard Online Insertion and Removal
Dell Networking OS detects the line card type when you insert a line card into a online chassis.
Dell Networking OS writes the line card type to the running-config and maintains this information as a
logical configuration if you remove the card (or the card fails).
Example of Viewing Line Card Configuration
Dell(conf)#do show linecard all
-- Line cards --
Slot Status NxtBoot ReqTyp CurTyp
---------------------------------------------------------------------------
0 not present
[output omitted]
Dell(conf)# %RPM0-P:CP %CHMGR-5-CARDDETECTED: Line card 0 present
Dell(conf)# do show linecard all
-- Line cards --
Slot Status NxtBoot
---------------------------------------------------------------------------
382
Version
7-5-1-71
Version
7-5-1-71
7-5-1-71
Version
ReqTyp CurTyp Version
Ports
Ports
High Availability (HA)