Redundancy Protocol - Dell S4810 Reference Manual

redundancy protocol

Enable hitless failover for a protocol.
S4810
Syntax
redundancy protocol
Protocols
lacp
xstp
Defaults Not enabled.
Command EXEC Privilege
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Version 8.3.7.0
Version 8.3.11.1
Version 7.7.1.0
reset stack-unit
Reset any designated stack member except the management unit (master unit).
S4810
Syntax
reset stack-unit hard
Parameters
stack-unit
hard
Defaults none
Command EXEC
Modes
Stacking
Enter the LACP protocol
Enter one of the following protocols: STP, RSTP, MSTP,
PVST.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
Introduced on the S-Series.
Enter the stack-unit number. For the S4810, the range is
from 0 to 5.
Reset the stack unit if the unit is in a problem state.
1607