Printer Continually Displays Warming Up - Xerox Phaser 6500 Service Manual

General Troubleshooting

Printer Continually Displays Warming Up

Initial Actions
4-72
Warning
Allow the Fuser to cool before servicing the printer.
• Reseat the Fuser.
• Cycle printer power.
• If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Fuser, PL6.1.1
■
Fuser Harness, PL6.1.2
■
LVPS, PL8.2.1
■
MCU Board, PL8.2.13
■
LVPS2 Harness, PL9.1.3
■
Troubleshooting Procedure Table
Step Actions and Questions
1 Check these connections
MCU Board P/J17 and Fuser
■
P/J171.
Fuser P/J171 and LVPS P/J47.
■
LVPS P/J501 and P/J502 and MCU
■
Board P/J14 and P/J15
Are the connectors secure?
2
Check the Fuser harness continuity.
1. Remove the Fuser.
2. Disconnect J17 from the MCU
Board and J47 from the LVPS.
Is the harness damaged?
NOTE P171 is attached to the
frame.
3 Check the LVPS harness continuity.
Disconnect J14 from the MCU Board
and J501 from the LVPS.
Is the harness damaged?
4 Replace the Fuser (page 8-10).
Does the error persist?
NOTE Reset the Fuser life counter
after installation of a new
Fuser (page 8-11).
Xerox Internal Use Only
http://www.manuals4you.com
Wiring and Plug/Jack Map References
"Map 1 - SFP Print Engine" on
■
page 10-6
"Map 4 - SFP MCU Board" on
■
page 10-9
"SFP Fuser" on page 10-33
■
Yes
Go to step 2.
Repair the
harness.
Repair the
harness.
Replace the
MCU Board
(page 8-138).
Phaser 6500/WorkCentre 6505 Service Manual
No
Reseat the
connectors.
Go to step 3.
Go to step 4.
Complete