NEC Univerge SV8100 Features And Specifications Manual page 1362

Issue 12.0
Related Features
Distinctive Ringing, Tones and Flash Patterns
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
Level 1 – these are the most commonly assigned programs for this feature.

Level 2 – these are the next most commonly assigned programs for this feature.

Level 3 – these programs are not often assigned and require an expert level working knowledge of

the system to be properly assigned.
Program
Program Name
Number
11-11-20 Service Code Setup (for Setup/
Entry Operation) – Change
Incoming CO and ICM Ring
Tones
11-11-21 Service Code Setup (for Setup/
Entry Operation) – Check
Incoming Ring Tones
15-02-02 MultiLine Telephone Basic Data
Setup – Trunk Ring Tone
15-02-03 Multiline Telephone Basic Data
Setup – Extension Ring Tone
2 - 1332
Description/Comments
If required, change the service
code used for changing the
incoming ring tones heard for CO
and ICM calls.
If required, change the service
code used for checking how the
incoming ring tones sound.
Set the tone (pitch) of the
incoming trunk ring for the
extension port you are
programming.
Set the tone (pitch) of the
incoming extension call ring for the
extension port you are
programming. Also refer to
program 15-08.
UNIVERGE SV8100
Assigned Data
1
MLT
(default = 720)
MLT
(default = 711)
1 = High
2 = Medium
3 = Low
4 = Ring Tone 1
5 = Ring Tone 2
6 = Ring Tone 3
7 = Ring Tone 4
8 = Ring Tone 5
(default = 2)
1 = High
2 = Medium
3 = Low
4 = Ring Tone 1
5 = Ring Tone 2
6 = Ring Tone 3
7 = Ring Tone 4
8 = Ring Tone 5
(default = 8)
Selectable Ring Tones
Level
2 3



