NEC Univerge SV8100 Features And Specifications Manual page 1775

UNIVERGE SV8100
Program
Program Name
Number
22-07-01 DIL Assignment
24-02-05 System Options for Transfer –
Message Wait Ring Interval Time
24-02-08 System Options for Transfer –
Delayed Transfer Timer for All
Department Groups
24-05-01 Department Group Transfer
Target Setup
Operation
To call a UCD Group:
1. At the multiline terminal, press Speaker.
- OR -
At single line telephone, lift the handset.
2. Dial the UCD group (department) extension or pilot number.
 The system routes the call to the first free telephone in the (UCD group) department.
To log out of your UCD (Department Calling) Group:

While you are logged out, UCD (Department Calling) cannot route calls to your extension.
1. Press Speaker.
2. Dial 650 and 1.
- OR -
Press Uniform Call Distribution Log In key (Program 15-07 or SC 751: 46).
 The key lights while you are logged out.
Uniform Call Distribution (UCD)
Description/Comments
For each trunk assigned Service
Type 4 in Program 22-02 above,
assign the DIL destination as the
Department Group pilot number
(as assigned in Program
11-07-01). (Department: Groups
1~64).
For Single Line Telephones
(SLTs) without message waiting
lamps, this is the time between
intermittent ringing. If this value is
0, the system rings once.
Determine the time a call should
ring a Department Group before
transferring the call.
Use the Speed Dialing area to
program the destination number of
the transferred telephone number
when a Department Group call is
transferred using Trunk-to-Trunk
Forwarding.
Assigned Data
1
Extension Number
(maximum eight digits)
(default not assigned)
0~64800 (seconds)
(default = 30)
0~64800 (seconds)
(default = 10)
0~1999
(default = 1999)
Issue 12.0
Level
2 3




2 - 1745