NEC Univerge SV8100 Features And Specifications Manual page 876

Issue 12.0
Program
Program Name
Number
11-01-01 System Numbering – Service
Code
14-01-24 Basic Trunk Data Setup –
Trunk-to-Trunk Outgoing Caller
ID through Mode
14-02-01 Analog Trunk Data setup –
Signaling Type (DP/DTMF)
14-05-01 Trunk Group – Trunk Group
Number
15-03-18 Single Line Telephone Basic
Data Setup – Select Special
Terminal
21-17-01 IP Trunk (SIP) Calling Party
Number Setup for Trunk
21-19-01 IP Trunk (SIP) Calling Party
Number Setup for Extension
2 - 846
Description/Comments
Set the system internal (Intercom)
numbering plan. The numbering
plan assigns the first and second
digits dialed and affects the digits
an extension user must dial to
access other extensions and
features, such as service codes
and trunk codes. If the default
numbering plan does not meet the
site requirements, use this
program to tailor the system
numbering to the site.
Enable/Disable the ability to send
the original Caller ID through when
the call is Forward Off-Premise.
Set the outgoing signaling type for
the tie trunk.
Assign trunks to trunk groups.
Used for selecting Special terminal
type (FAX or Modem). This setting
influences how data is transmitted
via SIP trunk.

Program 15-03-03 must be
set to 1 (Special) to use this
feature.
Assign the Caller Party Number for
each IP trunk. The assigned
number is sent to the central
office when the caller places an
outgoing call. If the Calling Party
Number is assigned by both
Program 21-17 and Program
21-18/ 21-19, the system uses the
entry in Program 21-18/21-19.
Assign the Calling Party Number
for each extension. The assigned
number is sent to the central office
when the caller places an outgoing
call. If the Calling Party Number is
assigned by both Program 21-17
and Program 21-18/Program
21-19, the system uses the data in
Program 21-18/Program 21-19.
IP Trunk – (SIP) Session Initiation Protocol
UNIVERGE SV8100
Assigned Data
1
Refer to System
Numbering Default
Settings table in the
UNIVERGE SV8100
Programming Manual
for a list of default

settings.
0 = Disable (No)
1 = Enable (Yes)
(default = 0)
0=Dial Pulse (10 PPS)
1=Dial Pulse (20 PPS)
2=DTMF
(default = 2)
Trunks 1~200
Trunk Port 1~200,

Group 1,
Priority 1~200
Type
0 = FAX
1 = Modem
(default = 0)
Up to 16 Digits
(1~0, , )
#

(default not assigned)

Up to 16 Digits
(1~0, , )
#

(default not assigned)

Level
2 3


