NEC Univerge SV8100 Features And Specifications Manual page 956

Issue 12.0
Hello this is a Broadcast message from (name of customer). Customers personal message played here.

To replay this message press 1.
If the customer presses 1 the message will repeat.

If the customer presses anything other than the digit 1, they will receive a message stating "that was an

invalid entry". After the incorrect digit is pressed three times the call is terminated.
If the call is unanswered:
If a new call goes unanswered (after one minute) the call will be marked as NO ANSWER in the

database and the call will end.
This call can be re-tried at an interval that is configurable.

The call will be re-tried a configurable amount of times and then the outbound calls to this number will not

be tried again.
Conditions
SV8100 CPU software Version 6.02 or higher is required.

SIP Peer to Peer (Program 10-26-03) must be disabled.

IVR – Broadcast only supports the G.711 Codec.

All SIP stations programmed as IVR – Broadcast ports must be in the same IP Duplication

group (Program 15-05-18).
The following Web Browsers are supported for configuring the IVR – Broadcast Server;

Internet Explorer 8, Internet Explorer 9, Firefox 3.6, Firefox 4 and Chrome 11.0.
The IVR – Broadcast Server can be configured for 8 through 16 ports.

When a external user dials an invalid DTMF digit while listening to a recording, the initial

message is stopped and the user is prompted to make the selection by dialing other digits.

The digits 1~9, 0, and
not displayed in the report.
If TOS settings are changed in the IVR – Broadcast application, a reset of the IVR –

Broadcast Server is required.
1 or 2 digit extension numbers are not supported in a system that has a IVR – Broadcast

Server installed.
If the SV8100 is configured for Forced Account codes, the account code must be entered

before the dialed number in the IVR – Broadcast Server. For example, if the system
account code is "123456" and the IVR – Broadcast Server needs to call 9-214-555-1111
then the entry in the IVR – Broadcast Server would be:
Default Settings
Disabled
2 - 926
can be programmed to show up in the callout log report, but the # character is

UNIVERGE SV8100
9 123456 2145551111.
 
IVR – Broadcast Server