Table 2-88 Voip Resource Chart - NEC Univerge SV8100 Features And Specifications Manual

Hide thumbs Also See for Univerge SV8100:
Table of Contents

Advertisement

Issue 12.0
When using Mobile Extension in a NetLink Network, the ISDN/PRI must be used in the
Primary System.
When using Set Relocation, and a terminal is re-located from one physical system to
another physical system, route programming must be made accordingly for 911 calls.
In a NetLink environment, IPK/IPK II Migration can only be used in the Primary system.
Secondary systems do not support IPK/IPK II Migration.
FoIP (Fax over IP) is supported in a NetLink Network.
With Version 4000 or higher software, DT700 series IP terminals and wireless IP terminals
can be registered to secondary systems in a NetLink environment, Softphones must still
register to the primary only.
For a network to be suitable for VoIP it must pass specific requirements. To ensure the site
meets these requirements, an IP ready check and a site survey must be completed at each
site before VoIP implementation.
One-way delay must not exceed 100ms
Round Trip delay must not exceed 200ms
Packet loss must not exceed 1%
Data switches must be manageable
Routers must provide QOS
Adequate bandwidth for estimated VoIP traffic
Depending on how QoS policies are built in the network, assignments may be needed in the
CPU
TDM
Terminal
Primary
IP Terminal
System
(DT700)
TDM
Secondary
Terminal
System 1
2 - 1492

Table 2-88 VoIP Resource Chart

Primary System
TDM
IP Terminal
Terminal
(DT700)
0
P:1
P:1
0
P:1
S1:1
S1:1
P:2
Secondary 1
CO
IP
TDM
Analog
Trunk
Terminal
/Digital
0
P:1
P:1
S1:1
P:1
P:2
S1:1
P:1
P:2
0
S1:1
S1:1
UNIVERGE SV8100
Secondary 2
CO
TDM
CO
Analog
Terminal
Analog
/Digital
/Digital
P:1
P:1
P:1
S1:1
S2:1
S2:1
S1:1
S2:1
S2:1
0
P1:1
S1:1
S2:1
S2:1
SV8100 NetLink

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents