NEC Univerge SV8100 Features And Specifications Manual page 1601

UNIVERGE SV8100
Program
Program Name
Number
34-09-02 ANI/DNIS Service Options –
Delimiter Dial Code
34-09-03 ANI/DNIS Service Options –
Route Setup of Receive Dial
34-09-04 ANI/DNIS Service Options –
Route Table Setup of Target Dial
34-09-05 ANI/DNIS Service Options – ANI/
DNIS Display as Target Dial
Name
T1 Trunking (with ANI/DNIS Compatibility)
Description/Comments
Define the character Telco uses
as a delimiter (see entries 1~5 in
Program 34-09-01).
Valid entries are: 0~9, , and .
#
Specify the source of the data the
system uses to route incoming
ANI/DNIS calls. If 2 is selected,
refer to Program 34-09-04.
Set how the system uses the route
data (gathered in Item 03) to route
incoming ANI/DNIS calls.
If option 2 is selected and the call
is routed using the DID table, up
to eight digits can be matched.
The number of expected digits set
in Program 22-09-01 must match
the ANI digits defined in Program
22-11-01. For example, if an ANI/
DNIS number received was
20355512343001 and
Program 22-09-01=4, then the
entry in Program 22-11-01 must
be 1234 with the defined target
extension.
If the call is routed using the ABB
table (0), up to 24 digits can be
matched. Define the range of the
ABB table to be used in Program
34-09-06. The data is then
compared to the entries in
Program 13-04-01 and then routed
according to Program 13-04-03.
Set whether or not ANI data
should be displayed on telephone
displays as part of Caller ID
display.
Assigned Data
1
1~9, 0, ,
 #
(default =  for
COS 1~15)
0 = Fixed Route (Item
08) (No Routing)
1 = Routes on
Received DNIS or
Address Data
2 = Routes on
Received ANI Data
(default = 0 for
COS 1~15)
0 = SPD Table
(Program 13-03)
1 = DID Table
(Program 22-11)
(default = 0 for
COS 1~15)
Caller ID Display:
0 = Display Off
1 = Display On
(default = 0 for
COS 1~15
Issue 12.0
Level
2 3




2 - 1571