NEC Univerge SV8100 Features And Specifications Manual page 1454

Issue 12.0
Program
Program Name
Number
11-12-11 Service Code Setup (for Service
Access) – Group Speed Dialing
13-01-01 Speed Dialing Option Setup –
Speed Dialing Auto Outgoing
Call Mode
13-01-03 Speed Dialing Option Setup –
Number of Common Speed
Dialing Bins
13-02-01 Group Speed Dialing Bins
13-03-01 Speed Dialing Group
Assignment for Extensions
13-04-01 Speed Dialing Number and Name
– Speed Dialing Data
13-04-02 Speed Dialing Number and Name
– Name
13-04-03 Speed Dialing Number and Name
– Transfer Mode
2 - 1424
Description/Comments
Customize the service code used
for group speed dialing.
Designate trunk or intercom
outgoing mode.
Designate the bins the system
uses for System Speed Dialing.
Designate the starting bin number
the system uses for Group Speed
Dialing.
For Group Speed Dialing, assign
extensions to Speed Dialing
groups.
Enter the System and Group
Speed Dialing numbers and
names.
Assign a name to each System
Speed Dial bin.
When the incoming caller ID
matches the number programmed
in the speed dial bin, this setting
determines the destination of the
call.
UNIVERGE SV8100
Assigned Data
MLT, SLT
(default = 4)
#
0 = Trunk Outgoing
Mode
1 = Intercom Outgoing
Mode
(default = 0)
0~2000
0 = No Common Speed
Dialing
(default = 1000)
01~64
(default not assigned)
01~64
(default = 1)
1~9, 0, ,
#
Pause (Press line key
1)
Recall/Flash (Press
line key 2)
@ = Code to wait for
answer supervision in
ISDN (Press line key 3)
(maximum 24 digits)
(default not assigned)
Maximum 12
Characters (Use dial
pad to enter name)
(default not assigned)
0 = Not Used
1 = Internal Dial
2 = Incoming Ring
Group (IRG)
(default = 0)
Speed Dial – System/Group/Station
Level
1 2 3







