NEC Univerge SV8100 Features And Specifications Manual page 1779

UNIVERGE SV8100
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
Level 1 – these are the most commonly assigned programs for this feature.

Level 2 – these are the next most commonly assigned programs for this feature.

Level 3 – these programs are not often assigned and require an expert level working knowledge of

the system to be properly assigned.
Program
Program Name
Number
11-01-01 System Numbering – Service
Code
11-02-01 Extension Numbering
14-02-09 Analog Trunk Data Setup – Busy
Tone Detection
Uniform Numbering Network
Description/Comments
Set the systems internal
(Intercom) numbering plan. The
numbering plan assigns the first
and second digits dialed and
affects the digits an extension user
must dial to access other
extensions and features, such as
service codes and trunk codes. If
the default numbering plan does
not meet the site requirements,
use this program to tailor the
system numbering to the site.
Caution
Improperly programming this
option can adversely affect system
operation. Make sure you
thoroughly understand the default
numbering plan before
proceeding.
Before changing your
numbering plan, use PCPro or
WebPro to make a backup copy
of your system data.
Set the extension number. The
extension number can have up to
eight digits. The first/second
digit(s) of the number should be
assigned in Program 11-01-01.
This allows an employee to move
to a new location (port) and retain
the same extension number.
Enable/Disable busy tone
detection for trunk ports.
Assigned Data
1
Refer to UNIVERGE
SV8100 Programming
Manual.

Up to eight digits
1 101
2 102
3 103

~ ~
99 199
100 3101
~ ~
512 3513
0 = Disable
1 = Enable
(default = 0)
Issue 12.0
Level
2 3

2 - 1749