NEC Univerge SV8100 Features And Specifications Manual page 1343

UNIVERGE SV8100
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
Level 1 – these are the most commonly assigned programs for this feature.

Level 2 – these are the next most commonly assigned programs for this feature.

Level 3 – these programs are not often assigned and require an expert level working knowledge of

the system to be properly assigned.
Program
Program Name
Number
11-10-46 Service Code Setup (for System
Administrator) – Watch Message
Setting
11-10-47 Service Code Setup (for System
Administrator) – Warning
Message Setting
11-10-48 Service Code Setup (for System
Administrator) – Auto Dial for
Security Sensor
11-10-49 Service Code Setup (for System
Administrator) – Auto Dial for
Remote Inspection
11-12-62 Service Code Setup (for Service
Access) – Security Sensor Reset
11-12-63 Service Code Setup (for Service
Access) – Watch Mode Start
11-12-64 Service Code Setup (for Service
Access) – Security Sensor Mode
Start
Security
Description/Comments
Service Code setting for Watching
message recording to VRS.
Service Code setting for Warning
message recording to VRS.
Service Code setting for
destination number when Warning
mode detected.
Service Code setting for
destination number when remote
inspection detects no answer.
Service Code setting for cancel
Warning message sending and
emergency call.
Service Code (SC) setting for on/
off watch mode. SC+1;Watch
mode start SC+0; Watch mode
end.
Service code + 1, after the timer
(Program 20-55-01) passes,
sensor signal is valid. Service
code + 0, sensor signal is invalid.
Assigned Data
1
MLT, SLT
(default = 614(NA/AT)/
714(OT))
MLT, SLT
(default = 615(NA/AT)/
719(OT))
MLT
(default = 617(NA/AT)/
748(OT))
MLT
(default = 619(NA/AT)/
749(OT))
MLT, SLT
(default = 716(NA/AT)/
837(OT))
MLT, SLT
(default = 717(NA/AT)/
817(OT))
MLT, SLT
(default = 719(NA/AT)/
819(OT))
Issue 12.0
Level
2 3







2 - 1313