NEC Univerge SV8100 Features And Specifications Manual page 933

UNIVERGE SV8100
DID Services for either ISDN – BRI or PRI:
Program
Program Name
Number
22-02-01 Incoming Call Trunk Setup
22-09-01 DID Basic Data Setup – Expected
Number of Digits
22-11-01 DID Translation Number
Conversion – Received Number
22-11-02 Translation Number Conversion
– Target Number
Calling Party Number Presentation for either ISDN – BRI or PRI:
Program
Program Name
Number
10-03-05 ETU Setup (PRTA PKG Setup) –
CLIP Information
ISDN Compatibility
Description/Comments
Assign the incoming trunk type for
each trunk.
For each DID Translation Table
(1~20), enter the number of digits
the table expects to receive from
the CO (eight maximum). For
example, for a table used with
3-digit DID service, enter 3.
For additional DID Services refer
to Direct Inward Dialing (DID) on
page 2-433.
For each DID Translation Table
entry (1~2000), specify the digits
received by the system.
For each DID Translation Table
entry (1~2000), specify the
extension the system dials after
translation.
Description/Comments
Based on this setting, the system
includes Presentation Allowed (1)
or Presentation Restricted (0) in
the Setup message to allow or
deny the Calling Party Number.
Program 15-01-04 must also be
set to 1 if this option is enabled.
Assigned Data
1
Trunks 1~200
0 = Normal
1 = VRS (second
dial tone if no
VRS installed)
2 = DISA
3 = DID

4 = DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode
Switching
(default = 0)
1~8
(default = 4)

(maximum eight digits)

(default not assigned)
(maximum 24 digits)
(default not assigned)

Assigned Data
1
0 = Disable
1 = Enable
(default = 1)

Issue 12.0
Level
2 3
Level
2 3
2 - 903