NEC Univerge SV8100 Features And Specifications Manual page 1600

Issue 12.0
Program
Program Name
Number
22-11-03 DID Translation Number
Conversion – DID Name
22-13-01 DID Trunk Group to Translation
Table Assignment
34-01-01 E&M Tie Line Basic Setup – DID/
E&M Start Signaling
34-01-02 E&M Tie Line Basic Setup –
Receive Dial Type for E&M Tie
Line
34-01-03 E&M Tie Line Basic Setup – E&M
Dial-In Mode
34-01-04 E&M Tie Line Basic Setup – E&M
Line Dial Tone
34-02-01 E&M Tie Line Class of Service
34-09-01 ANI/DNIS Service Options –
Receive Format
2 - 1570
Description/Comments
For each DID Translation Table
entry (1~2000), specify the name
that should show on the dialed
extension display when it rings.
Assign DID translation tables to
trunk groups.
For each ANI/DNIS trunk, set the
start signaling mode to 1.
For DID and tie trunks, set the
trunk signaling type (Dial Pulse or
DTMF).

Program 34-01-02 must be
set to (2) = MF in order for T1
ANI to work.
Determine if the incoming Tie Line
call should be directed as an
intercom call (0) or if it should
follow the DID Translation Table in
Program 22-11 (1).
Enter 1 if the Tie Line should send
dial tone to the calling system after
the call is set up. Enter 0 if the Tie
Line should not send dial tone.
Assign a Class of Service (1~15)
to a Tie Line. The Class of Service
options are defined in Program
20-14. For each Tie Line, you
make a separate entry for each
Night Service mode.
Specify the format of the ANI/
DNIS data received from the
Telco. Make sure your entry is
compatible with the service the
Telco provides (4 = ANIDNIS
[ = Delimiter Code]).

If Program 34-01-02 is set to
(2) = MF, this Program works
 
only as 4 = ANI DNIS
T1 Trunking (with ANI/DNIS Compatibility)
UNIVERGE SV8100
Assigned Data
Maximum 12 digits
(default not assigned)
DID Translation
Tables: 1~20
Trunk Groups: 1~100
0~20
(0 = No Setting)
(default = 1)
0 = 2nd Dial Tone
1 = Wink (default)
2 = Immediate
3 = Delay
(default = 1)
0 = DP
1 = DTMF
2 = MF
(default = 1)
0 = Specify Extension
Number (Intercom)
1 = Use Conversion
Table (NTT)
(default = 0)
0 = Disable (No)
1 = Enable (Yes)
(default = 1)
Day/Night Mode
1~8
Class: 1~15
(default = 1)
0 = Address
1 = ANI
2 = DNIS
3 = ANIAddress
4 = 
ANI DNIS
 
5 = DNISANI
(
 = Delimiter Code)
(default = 0 for

COS 1~15)
Level
1 2 3







