NEC Univerge SV8100 Features And Specifications Manual page 1416

Issue 12.0
The CD-PVAA blade with SMB8000 Conference Bridge application can be used with

Version 1.11 or higher software on the UNIVERGE SV8100 system.
The support PC must be connected directly to the CD-PVAA SMB8000 Conference Bridge

and not connected via a Hub or Router when performing any of the following functions:
Database Restoration

Application Upgrade

Application Package Upgrade

Service Package Upgrade

When the CD-PVAA blade is set for two, four-party conferences, ports 1~4 can be set to the

same Master Hunt Group, and ports 5~8 can be set to a different Master Hunt Group using
Program 11-07-01 (Department Group Pilot Numbers) and Program 16-02-01 (Department
Group Assignment for Extensions). This allows two different Pilot Numbers for each
conference.
- OR -
If only one Pilot number is needed, put all eight ports in one hunt group using Program

16-02-01 (Department Group Assignment for Extensions). When the password is entered,
the conference selected is the conference you enter.
The administrator must perform the Setting Procedures before the Conference Bridge can

be used.
Each CD-PVAA blade reduces the number of stations by eight or 16 depending on license.

Each PVAA CNF 8 or 16 reduces the total number of station ports available in the SV8100

chassis by eight or 16 depending on the number of licensed ports.
The PVAA CNF blade uses Conference Ports (CNF) ports assigned in Program 10-03-01

Unit Configuration.
The PVAA CNF is a standalone Conference Bridge that cannot be linked with another CNF

ETU to increase the number of conferences.
Conference ports should be placed in a Class of Service (COS) with no enabled alert tones.

In Preset conference, all participants have the same conference password. Default

passwords are:
Conference 1 1111

Conference 2 2222

Conference 3 3333

Conference 4 4444

2 - 1386
UNIVERGE SV8100
SMB8000 Conference Bridge