NEC Univerge SV8100 Features And Specifications Manual page 1111

UNIVERGE SV8100
Program
Program Name
Number
22-01-12 System Options for Incoming
Calls – Mobile Extension Answer
Time
22-11-01 DID Translation Number
Conversion – Received Number
22-11-02 DID Translation Number
Conversion – Target Number
22-11-13 DID Translation Number
Conversion – Identify for Mobile
Extension
80-01-01 Service Tone Setup – Tone 44,
External Dial Tone
80-01-01 Service Tone Setup – Tone 54,
Progress Tone
80-01-01 Service Tone Setup – Tone 57,
Off-Hook Beep Tone - Headset
Earpiece ringing Tone
80-03-01 DTMF Tone Receiver Setup –
Detect Level
Mobile Extension
Description/Comments
Determines the amount of time
before the mobile extension will
answer with internal dial tone.
Extend this timer long enough for
1 ring cycle to complete, giving the
mobile extension user time to
hang up and wait for callback.
Define the digits received by the
system for the telephone number
on which a Mobile Extension user
calls into the system.
For the DID number defined in
Program 22-11-01, enter the
extension number for the Mobile
Extension user.
Determines when a Mobile
Extension number calls in on a
DID if it will provide an Internal
Tone (1) or route the call as
programmed (0).
It is necessary to adjust the DID/
DISA dial tone (tone 44) to a
Repeat Count of 250 (by default,
this is set to 0). The system must
be reset for this change to take
affect.
By default, when calling a Mobile
Extension, the Progress Tone is
played to the caller.
If required, change the tone heard
when a Mobile Extension user
goes off hook to answer a call prior
to pressing *. The system must be
reset for this change to take affect.
Select the Detect Level to be used
for DTMF Tone detection. For the
extension DTMF, this entry must
allow for a detection of -25dBm.
Set the minimum detection level in
Program 80-03-03. The system
must be reset for this change to
take affect.
Assigned Data
1
1~64800 seconds
(default = 3 seconds)

Maximum eight digits
(default not assigned)

Maximum 24 digits
(default not assigned)

0 = Off
1 = On

(default = 0)
0~255 (0 = until
On-Hook)
Refer to Table 2-33
Service Tone Setup
Defaults, Program
80-01-01 on page
2-703
Refer to Table 2-33
Service Tone Setup
Defaults, Program
80-01-01 on page
2-703
Refer to Table 2-33
Service Tone Setup
Defaults, Program
80-01-01 on page
2-703
0 = 0dBm ~ -25dBm
1 = -5dBm ~ -30dBm
2 = -10dBm ~ -35dBm
3 = -15dBm ~ -40dBm
4 = -20dBm ~ -45dBm
5 = -25dBm ~ -50dBm
6 = -30dBm ~ -55dBm
default:
Type 1~5 = 0
Issue 12.0
Level
2 3




2 - 1081