NEC Univerge SV8100 Features And Specifications Manual page 1455

UNIVERGE SV8100
Program
Program Name
Number
13-04-04 Speed Dialing Number and Name
– Transfer Destination Number
13-04-05 Speed Dialing Number and Name
– Incoming Ring Pattern
13-05-01 Speed Dialing Trunk Group –
Trunk Group Number
14-02-06 Analog Trunk Data Setup –
Pause at 1st digit after Line Seize
in Manual Dial Mode
15-02-04 Multiline Telephone Basic Data
setup – Redial (Speed Dial )
Control
Speed Dial – System/Group/Station
Description/Comments
When the incoming caller ID
matches the number programmed
in the speed dial bin, this setting
determines the destination of the
call.
Define the ring tone for the caller
ID routed call.
For each System Speed Dialing
number, enter the routing option
Trunk Group Number (1~100) to
dial out on.
Enable/Disable the system ability
to pause after dialing the first digit.
Assign the extension Redial key
for either Common or Group
Speed Dialing.
Assigned Data
1
If Transfer mode is
(Refer to 13-04-03):
1 = Internal Dial Mode
1~9, 0, , , P, R, @
#

(Maximum 24
Characters)
2 = Incoming Ring
Group
0 ~ 100 (IRG Number)
P=Pause R=Recall
@= Additional Digits
when using ISDN
functionality
(default not assigned)
Incoming Ring Pattern
0 = Normal Pattern
1~4 = Tone Pattern
(1~4)
5~9 = Scale Pattern
(1~5)
10~13 = Tone Pattern
(5~8)
(default = 0)
0 = No setting
1~100
(default = 0)
0 = No Pause (No)
1 = Pause (Yes)
(default = 1)
0 = Common and
Individual Speed
Dialing
1 = Group Speed
Dialing
(default = 0)
Issue 12.0
Level
2 3





2 - 1425