Pbx Compatibility - NEC Univerge SV8100 Features And Specifications Manual

Hide thumbs Also See for Univerge SV8100:

Table of Contents

UNIVERGE SV8100

You can connect your telephone system trunks to Centrex/PBX lines, rather than to Telco trunk circuits.

This makes the trunk inputs to the system 500/2500 type compatible Centrex/PBX extensions, rather

than Telco circuits. PBX Compatibility lets the system be a node (i.e., satellite) in a larger private

telephone network. To place outside calls when the system is behind a PBX, telephone system users

must first dial the PBX trunk access code (usually 9).

The system provides the following PBX Compatibility options:

PBX Trunk Access Code Screening

The system can monitor the numbers users dial and screen for PBX trunk access codes. The

system can screen up to four groups of trunk access codes. The codes can have one or two digits,

consisting of the digits 0~9,

PBX Trunk Toll Restriction

The system can provide the Toll Restriction for the PBX trunk, or restriction can be handled solely

by the connected PBX. If the telephone system provides the restriction, it restricts the digits dialed

after the PBX access code.

PBX Call Restriction

When the telephone system does the Toll Restriction, it can further restrict users from dialing PBX

extensions. In this case, the only valid numbers are those dialed after the PBX trunk access code.

The only PBX facility telephone system users can access are the PBX outside trunks.

Automatic Pause

The system automatically pauses when it sees a PBX trunk access code during manual dialing,

Speed Dialing, Last Number Redial, Repeat Redial and Save Number Dialed. This gives the

connected PBX time to set up its trunk circuits.

When using Account Codes, do not use

trunk stops sending digits to the central office.

The system automatically pauses after it finds a PBX access code in a Speed Dialing bin.

If Speed Dialing routes a call to a PBX trunk, it does not automatically insert a PBX access

code. It outdials the digits just as they are stored.

Users answer incoming calls on PBX trunks just like other trunks. All relevant access and

Ring Group programming applies.

PBX Compatibility

. (You use Line Key 1 as a wild card entry.)

in a PBX access code. Otherwise, after the

PBX Compatibility

Show Quick Links

Table of Contents