NEC Univerge SV8100 Features And Specifications Manual page 1336

Issue 12.0
Watch mode can be started and stopped manually using Service code (Program 11-12-63)

or function key (SC752:
press again to stop the message.
Security sensor can be started and stopped automatically using settings in

Program 20-48-01.
Security sensor can start and stop manually using Service code (Program 11-12-64) or

function key (SC752:
expires, then the function key turns red. The system can detect a signal from the sensor.
The Watching Message:

Is displayed after the timer in Program 20-44-04 expires.

Can be edited using the Service Code in Program 11-10-20.

Can be recorded up to a maximum of two minutes.

The Length of the watch message depends on the length of the recorded VRS message.

Internal Paging will only play the message when the targeted terminal is in an Idle state.

If an ordinary Internal Paging message is sent, the message is aborted and the watching

message is played.
A Warning message has a higher priority than a Watch message when both occur at same

time.
When using an external speaker, start and end tones are not supported.

When the security sensor detects a signal the following options can be set:

A Warning message is sent.

An Emergency call is sent.

A Warning message and an Emergency call are both sent.

Calling to an emergency destination:

The emergency number is set in Program 20-46-05.

Outside call routing uses Program 13-05-01.

If Program 13-05-01 is set to 0, outside call routing uses the settings in Program 14-06-01 and

search for data from route table 100 using order 4 in descending order. If Program 14-06-01 is
set to 0, outside calls are not supported.
If an outgoing call is set in a system, emergency calls cannot go through. When using outgoing

call restriction, Class 1 toll restriction is followed.
If all trunks are busy, the emergency call is not sent. If this occurs, Alarm Type 33 is used.

2 - 1306
32) assignment. After 10 seconds a warning message is provided,

 33). Function key (  33) blinks until the timer in Program 20-55-01
UNIVERGE SV8100
Security