Ip Rip Receive Enable - D-Link xStack DGS-3620 Series Reference Manual

DGS-3620 m/ mSW Rls. 1.02.000

13-5 ip rip receive enable

ip rip receive enable
no ip rip receive enable
Syntax
Description
Default
Command Mode
Usage Guideline
Example
Switch# configure terminal
Switch(config)# interface vlan 1
Switch(config-if)# no ip rip receive enable
CLI Reference Guide
Use this command to receive RIP packets on an RIP interface. Use the no form
of this command to prohibit receiving RIP packets on the interface.
None.
By default receiving RIP packets is enabled on each RIP interface.
Interface configuration mode.
Use the no form of this command to prevent from receiving RIP packets on the
interface, the RIP protocol should not receive the packets coming from the
interface.
On one interface whose sending packets is disabled or Version 1, disabling
receiving packets will cause the configuration of authentication on this interface
to be cleared and can't be restored when enable interface receiving packets
again. The authentication needs to be reconfigured.
With the no form of this command, the configuration set by ip rip receive
version command will be cleared. After enable interface receiving packets again,
the receive version of the interface depends on global version setting with the
version command.
You can verify your settings by entering the show ip rip or show ip rip interface
command.
Configure the System interface (vlan 1) to not receive RIP packets:
ip rip receive enable
420