When The Measurement Is Complete - Agilent Technologies E5500A User Manual

Phase noise measurement system

Hide thumbs Also See for E5500A:

Table of Contents

Measurement is

4. The system software will then prompt you to set the phase noise

software's meter to quadrature by adjusting the phase shifter until the

meter indicates 0 volts, then press Continue.

5. The system will now measure the noise data.

The system can now run the measurement. The segment data will be

displayed on the computer screen as the data is taken until all segments have

been taken over the entire range you specified in the Measurement

definition's Type and Range.

When the measurement is complete, refer to

Measurement Results"

for help in evaluating your measurement results.

Figure 9-3 on page 9-14

Agilent Technologies E5500 Phase Noise Measurement System 9-13

Residual Measurement Examples

Amplifier Measurement Example

Chapter 15, "Evaluating Your

shows a typical phase noise curve for an RF