Basic Operations for RF Devices Measurement
STEP 2. Setting Measurement Conditions
Setting the Measurement Points, Sweep Parameter and Sweep Type
Step 1. Click
Step 2.
Number Of Points
Step 3. Select
Figure 3-21
Step 3
NOTE
Setting sweep parameter to
Setting the Source Mode and CW Frequency
Step 1. Click
Step 2. Select
Step 3. Select
Figure 3-22
Step 3
56
on the
Sweep Setup...
Stimulus
box is set to
in the
Power
Sweep Parameter
Power
on the
Source...
Stimulus
in the
box (Figure 3-16).
Current
Osc Unit
box and type
CW Freq
[1] [0] [0] [M] [Enter]
menu (Figure 3-13).
in the initial state.
201
box (Figure 3-21).
automatically sets sweep type to Linear.
menu (Figure 3-15).
on the keyboard (Figure 3-22).
Chapter 3