Setting The Sweep Time - Agilent Technologies ENA Series User Manual

Rf network analyzer
Hide thumbs Also See for ENA Series:
Table of Contents

Advertisement

Setting the Number of Points
Step 1. Press
will be set.
Step 2. Press
Step 3. Press
Step 4. Using the ENTRY block keys on the front panel, input the desired number of points.

Setting the Sweep Time

Sweep time is the time it takes to complete a sweep for each stimulus (source) port. Two
modes are available for setting the sweep time: manual sweep time mode and automatic
sweep time mode.
Manual Sweep Time Mode
Automatic Sweep Time Mode
Figure 3-6 shows the definitions of the sweep time and the sweep delay time.
Figure 3-6
Sweep Time and Sweep Delay Time
Sweep delay is time before starting a sweep for each stimulus (source) port
Chapter 3
or
.
.
Points
In this mode, the sweep time is set manually. Once the sweep
time is set, changes in measurement conditions will not affect
the sweep time as long as it is within the analyzer's capability.
If the sweep time becomes lower than the analyzer's lower
sweep time limit, the sweep time will be reset to the shortest
time within the conditions. If the sweep time exceeds the
analyzer's upper sweep time limit, the sweep time will be
reset to the longest time within the conditions.
The sweep time is always kept to the shortest time possible
with the current measurement conditions.
Setting Measurement Conditions
to select the channel for which the number of points
Stimulus Settings
63

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

E5070E5071a

Table of Contents