Enable Bgp Neighbor Capability - Extreme Networks ExtremeWare XOS Command Reference Manual

Version 11.3

Hide thumbs Also See for ExtremeWare XOS:

Table of Contents

enable bgp neighbor capability

enable bgp neighbor [all | <remoteaddr>] capability [ipv4-unicast | ipv4-

multicast | route-refresh]

This command enables BGP Multiprotocol (MP) and route-refresh capabilities for neighbor.

Syntax Description

ipv4-unicast

ipv4-multicast

route-refresh

All capabilities are disabled by default.

If no address family is specified, IPv4 unicast is the default.

Usage Guidelines

This command is not currently supported, and is not recommended for use.

This command enables BGP Multiprotocol and route-refresh capabilities for one or all neighbors. After

the capabilities have been enabled, the BGP neighbor will announce its capabilities to neighbors in an

OPEN message.

The following command disables the route-refresh feature for all neighbors:

enable bgp neighbor all capability route-refresh

This command was first available in ExtremeWare XOS 10.1.

This command required an Advanced Core license in ExtremeWare XOS 11.1.

ExtremeWare XOS 11.3 Command Reference

Specifies all neighbors.

Specifies an IP address of a BGP neighbor.

Specifies BGP MP unicast capabilities.

Specifies BGP MP multicast capabilities.

Specifies ROUTE-REFRESH message capabilities.

enable bgp neighbor capability

Extremeware xos 11.3