Configure Pim Register-Rate-Limit-Interval - Extreme Networks ExtremeWare XOS Command Reference Manual

configure pim register-rate-limit-interval

configure pim register-rate-limit-interval
configure pim register-rate-limit-interval <interval>
Description
Configures the initial PIM-SM periodic register rate.
Syntax Description
interval Specifies an interval time in seconds. Range is 0 - 60. Default is 0.
Default
Default is 0.
Usage Guidelines
Configuring a non-zero interval time can reduce the CPU load on the first hop switch, in case register
stop messages are not received normally.
When a non-zero value is configured, the first hop switch sends a few register messages and then waits
for a corresponding register stop from RP for < > seconds. The process is repeated until the register
time
stop is received. This command should be used when the (S,G) tree between the first hop router and the
RP is not converging quickly.
The default value is zero in default mode, the switch sends continuous register messages until the
register stop is received.
Example
The following command configures the initial PIM register rate limit interval:
configure pim register-rate-limit-interval 2
History
This command was first available in ExtremeWare XOS 10.1.
Platform Availability
This command is available on all platforms.
1551
ExtremeWare XOS 11.3 Command Reference