bridge address
Use the bridge address command in Interface Configuration mode to add a
static MAC-layer station source address to the bridge table. To delete the
MAC address, use the no form of the bridge address command (using the no
form of the command without specifying a MAC address deletes all static
MAC addresses belonging to this VLAN).
Syntax
bridge address
number
} [permanent]
no bridge address [
mac-address — A valid MAC address in the format xxxx.xxxx.xxxx.
•
interface — A valid Ethernet port.
•
port-channel-number — A valid port-channel number.
•
•
permanent — The address can be deleted only by using the no bridge
address command.
Default Configuration
No static addresses are defined. The default mode for an added address is
permanent.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
This command has no user guidelines.
Example
The following example adds a permanent static MAC-layer station source
address 3aa2.64b3.a245 to the bridge table.
console(config-if-vlan1)#bridge address
3AA2.64B3.A245 ethernet 1/g8 permanent
218
Address Table Commands
mac-address
{ethernet
mac-address
]
interface
|port-channel
port-channel-