Dell PowerConnect 6224 Command Line Interface Manual page 221

console(config)#interface vlan 8
console(config-if-vlan8)#bridge multicast address
0100.5e02.0203 add ethernet 1/g1-1/g9, 1/g2
bridge multicast filtering
Use the bridge multicast filtering command in Global Configuration mode
to enable filtering of Multicast addresses. To disable filtering of Multicast
addresses, use the no form of the bridge multicast filtering command.
Syntax
bridge multicast filtering
no bridge multicast filtering
Default Configuration
Disabled. All Multicast addresses are flooded to all ports of the relevant
VLAN.
Command Mode
Global Configuration mode
User Guidelines
If switches exist on the VLAN, do not change the unregistered Multicast
addresses' state to drop on the switch ports.
If switches exist on the VLAN and IGMP snooping is not enabled, use the
bridge multicast forward-all command to enable forwarding all Multicast
packets to the Multicast routers.
Example
In this example, bridge Multicast filtering is enabled.
console(config)#bridge multicast filtering
221
Address Table Commands