Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 85

Example 7 host1(config)#privilege-group membership clear dailyAdmin
host1(config)#privilege-group membership dailyAdmin add dailyTroll
In Example 7, privilege group 10 alias dailyAdmin has one member: privilege group
6 alias dailyTroll.
host1(config)#no privilege-group membership 9
Example 8
Example 8 reverts one privilege group membership to its default setting. Prior to the
execution of this command, the following group memberships were in place:
Reverting privilege group 9 to its default gives it one member: privilege group 8. This
creates the circular dependency: 8 contains 12, 12 contains 11, 11 contains 10, 10
contains 9, and 9 contains 8.
Example 9 host1(config)#no privilege-group membership
In Example 9, privilege group membership reverts to the default setting. All privilege
groups revert to hierarchical settings: 15 contains 14, 14 contains 13, 13 contains
12, and so forth. Privilege group 0 is reachable from every privilege group.
host1(config)#no privilege-group membership 7
Example 10
In this example, one privilege group membership reverts to its default setting. Privilege
group 7 contains group 6.
Example 11 host1(config)#no privilege-group alias
In Example 11, all alias settings are removed.
Example 12
host1#show privilege group
privilege
group
----------
0
1
2
3
group member reachable
8 12 12,0
9 -- 0
10 9 9,0
11 10 10,9,0
12 11 11,10,9,0
privilege directly
group reachable
alias groups
---------- --------
minUser --
-- --
-- 1
-- 2
Chapter 2: Command-Line Interface
all
reachable
groups *
-----------------
--
0
0 1
0 1 2
CLI Command Privileges
55