Table of Contents
Advertisement
JUNOSe 11.1.x System Basics Configuration Guide
Overview
Managing the E Series router involves a variety of tasks. This chapter covers those
tasks associated with the router in general rather than specific networking protocols.
Each section in the chapter covers a different topic; where appropriate, a section
contains an overview of the topic, configuration tasks, and information about
monitoring the associated settings.
For additional management information, CLI commands, and procedures, refer to
the following table.
Platform Considerations
System management is supported on all E Series routers.
For information about the modules supported on E Series routers:
Naming the System
When you receive the router, it has a factory default host name. To rename the
router, use the hostname command.
hostname
252
Overview
Task
Find detailed information about
commands described in this chapter.
Configure the system as an SNMP agent.
Set system passwords.
Write CLI macros.
Boot the system.
Manage line modules and SRP modules.
See the ERX Module Guide for modules supported on ERX7xx models, ERX14xx
models, and the ERX310 Broadband Services Router.
See the E120 and E320 Module Guide for modules supported on the E120 and
E320 Broadband Services Routers.
Use to rename the router.
The assigned name is displayed in the command-line interface (CLI) prompts.
Example
Reference
JUNOSe Command Reference Guide
"Configuring SNMP" on page 147
"Managing the System" on page 251
"Managing Modules" on page 355
"Booting the System" on page 509
"Managing Modules" on page 355
Advertisement
Table of Contents
Troubleshooting
