Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 105

Table 10: Command Mode Overview (continued)
Mode Name Use of Mode
IPSec Peer Public Key
Configuration
IPSec Transport Profile
Configuration
IPSec Tunnel Profile
Configuration
IP Tunnel Destination
Profile Configuration
IPv6 Local Pool
Configuration
Access to Mode
Enter an ISAKMP/IKE
public key that a
remote peer uses for
RSA authentication
without the need for a
digital certificate.
host1(config-peer-
public-key)#
Configure a profile for
L2TP over IPSec.
host1(config-ipsec-transport-
profile)#
Configure a profile for
IPSec tunnels.
host1(config-ipsec-tunnel-
profile)#
Create a profile for
dynamic GRE or
DVMRP tunnels
host1(config-dest-profile)#
Configure IPv6 local
address pools.
host1(config-ipv6-local)#
Chapter 2: Command-Line Interface
Exit from Mode
From Global
Configuration mode,
use the ipsec key
pubkey-chain rsa
command.
Prompt:
From Global
Configuration mode,
use the ipsec transport
profile command.
Prompt:
From Global
Configuration mode,
use the ipsec tunnel
profile command.
Prompt:
From Global
Configuration mode,
use the gre destination
profile command or the
dvmrp destination
profile command and
specify a destination
profile name.
Prompt:
From Global
Configuration mode,
use the ipv6 local-pool
command and specify
the name of the IPv6
local address pool.
Prompt:
Accessing Command Modes
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
75