Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 255

Table 29: Mapping Bulkstats Output to MIB Flies and CLI Configurations for Policy Schema (continued)
Bulkstats Output
Column Name MIB File
ifHCInOctets RFC2863
ifHCInUcastPkts RFC2863
ifInDiscards RFC1213
MIB Object Name CLI Configuration
ifHCInOctets in-octets
ifHCInUcastPkts in-ucast-pkts
ifInDiscards in-discards
Chapter 4: Configuring SNMP
Description
The total number of octets
received on the interface,
including framing
characters. This object is a
64-bit version of ifInOctets
Discontinuities in the value
of this counter can occur at
re-initialization of the
management system, and
at other times as indicated
by the value of
ifCounterDiscontinuityTime
The number of packets,
delivered by this sub-layer
to a higher (sub-)layer,
which were not addressed
to a multicast or broadcast
address at this sub-layer.
This object is a 64-bit
version of ifInUcastPkts
Discontinuities in the value
of this counter can occur at
re-initialization of the
management system, and
at other times as indicated
by the value of
ifCounterDiscontinuityTime
The number of inbound
packets which were chosen
to be discarded even
though no errors had been
detected to prevent their
being deliverable to a
higher-layer protocol. One
possible reason for
discarding such a packet
could be to free up buffer
space
Discontinuities in the value
of this counter can occur at
re-initialization of the
management system, and
at other times as indicated
by the value of
ifCounterDiscontinuityTime
Collecting Bulk Statistics
225