Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 216

JUNOSe 11.1.x System Basics Configuration Guide
enable
event
existence-test
186
Configuring the SNMP Server Event Manager
(Optional) Use the discontinuity-id-type option to specify a discontinuity ID
type (either timeStamp or timeTicks). The discontinuity ID type indicates the
time value that you expect for a specific sample.
Use the no version to turn off delta sampling and use absolute sampling (the
default).
See delta-sampling.
Use to enable an event configuration or trigger configuration.
Example 1 Event Configuration Mode
host1(config-mgmtevent-event)#enable
Example 2 Trigger Configuration Mode
host1(config-mgmtevent-trigger)#enable
Once enabled, you cannot edit an event or trigger configuration (even when it
is disabled). To change an enabled event or trigger, you must delete it and
re-create it.
There is no no version.
See enable.
Use to create an event and access the event configuration mode of the SNMP
server event manager.
Example
host1(config-mgmtevent)#event sysadmin failuretrigger
host1(config-mgmtevent-event)#
To leave the event configuration mode, use the exit command.
Use the no version to remove the event.
See event.
Use to define existence test values for the trigger that you are configuring,
including binding an event to the existence-test trigger, specifying a startup
condition, and defining an existence-test type.
You can specify one or both startup conditions in the same command. You can
specify one, two, or all three test types in the same command.
Example 1 Binding an event to the Boolean-test trigger
host1(config-mgmtevent-trigger)#existence-test event sysadmin existenceTrigger
Example 2 Specifying a startup condition