Table of Contents
Advertisement
Configure a route to reach the network host.
3.
host1#configure
Configuring from terminal or file [terminal]?
Enter configuration commands, one per line. End with CNTL/Z.
host1(config)#ip route ipNetwork networkMask ipNextHop
Press Ctrl+z to return to Privileged Exec mode.
4.
Determine whether the router has been configured to recognize the network
5.
host.
host1#show host
If the network host is listed, go to Step 8. Otherwise, proceed with Step 6.
Add an entry to the Static Host Table so that the router can access the network
6.
host. Use the host command to specify the network hostname and IP address.
host1#configure
Configuring from terminal or file [terminal]?
Enter configuration commands, one per line. End with CNTL/Z.
host1(config)#host hostName ipAddress ftp loginname password
Press Ctrl+z to return to Privileged Exec mode.
7.
Use the ping command to determine whether the router can now reach the
8.
network host.
host1#ping hostname
If the router cannot reach the network host, verify that you correctly performed
the previous steps in this procedure and that the network host is operational.
Task 6: Copy the Release Files to the Network Host
If you downloaded the software from the Juniper Networks website as a .zip file,
uncompress the files to a directory, and copy the release files to the network host.
If you are accessing the release files from one of the software CDs that you created
from the downloaded software image package, you must mount the CD. The way
you mount the CD on the network host depends on the type of network host you
use, the operating system, and the way your network is configured. To find out how
to mount a CD on the network host, review the manual for the operating system, or
contact your network administrator.
Task 7: Copy the Software Release File to the Router
To copy the software release file to the router, use the copy command.
Be sure to specify the correct software release (.rel) filename for the router you are
using, as described in "Identifying the Software Release File" on page 126.
Chapter 3: Installing JUNOSe Software
Installing Software When a Firewall Does Not Exist
135
Advertisement
Table of Contents
Troubleshooting
