Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 218

JUNOSe 11.1.x System Basics Configuration Guide
set
snmp-server management-event
snmp-server security
threshold-test
188
Configuring the SNMP Server Event Manager
host1(config-mgmtevent)#sample value-id 1.3.6.1.2.1.60.1.2.1.1.7
Use the no version to remove the MIB object from the trigger. Removal returns
the sample value-id to its default (0.0).
See sample.
Use to perform an SNMP set operation under certain event conditions.
Example Sets the administrative status of interface 123 to down (2)
host1(config-mgmtevent-event)#set context-name router1
host1(config-mgmtevent-event)#set id 1.3.6.1.2.1.2.2.1.7.123
host1(config-mgmtevent-event)#set value 2
Use the no version to remove the set operation.
See set.
Use to launch the SNMP server event manager mode on each virtual router on
which you plan to manage events.
Example
host1(config)#snmp-server management-event
host1(config-mgmtevent)#
To leave the SNMP server event manager, use the exit command.
Use the no version to delete all the management events.
See snmp-server management-event.
Use to specify a security access level for the SNMP agent.
Example
host1(config)#snmp-server security read
Use the no version to return to the SNMP security level to its default (no-access).
See snmp-server security.
Use to define the threshold values for the trigger that you are configuring,
including specifying rising and falling values, a startup threshold condition, and
binding an event to the threshold-test trigger.
Example 1 Specifying absolute values
host1(config-mgmtevent-trigger)#threshold-test absolute-value rising 2000 falling
1900