Table of Contents
Advertisement
To reload the router you must do either of the following:
If you perform one of the following actions, you must reset the configuration of the
router to factory default:
You cannot use the slot accept command to force the router to accept the new SRP
module.
When you have installed the SRP module in the new location, reset the configuration
of the router to factory defaults as follows:
1.
2.
3.
For more information about the reload and boot config commands, see "Booting
the System" on page 509.
adapter accept
Issue the reload force command.
Issue the slot erase command followed by the reload command.
Replace a 5-Gbps SRP module with a 10-Gbps SRP module or vice versa.
Transfer an SRP module from an ERX7xx router to a Juniper Networks ERX1410
router or vice versa.
Reload the operating router, then press mb key sequence (case-insensitive) during
the countdown.
host1#reload
Reboot the router with the factory defaults.
:boot##boot config factory-defaults
Reload the operating router.
:boot##reload
Use to delete the configuration of the IOA in the specified IOA bay after you
install a different type of IOA.
This command enables you to create a fresh configuration for the module installed
in the IOA bay.
You can also use this command to accept an empty IOA bay that was previously
occupied.
Issuing this command reboots the line module associated with the IOA, but it
does not erase the line module's configuration. To erase the configuration of the
line module and its associated IOAs, issue "slot accept" on page 370 command.
Issuing this command erases the interfaces associated with the specified IOA.
To erase the interfaces for both IOAs installed in a slot, issue the slot accept
command.
Depending on the previous configuration of the slot, the system might take a
few moments to execute this command.
Replacing IOAs on the E120 Router and the E320 Router
Chapter 6: Managing Modules
369
Advertisement
Table of Contents
Troubleshooting
