Managing The Ethernet Port On The Srp Module - Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual

JUNOSe 11.1.x System Basics Configuration Guide
% De-activation failed.
The command fails because hf63037.hfx is dependent on hf63036.hfx.
Interdependent hotfixes must be deactivated and disarmed in the reverse order that
they were activated.
When 6-0-1p0-5.rel is re-armed and the router reloaded, the hotfix loader determines
that the startup hotfixes, hf63036.hfx and hf63037.hfx, are incompatible with the
release. It disarms these hotfixes. The user decides to delete the now unnecessary
hotfixes from the router.
host1# delete hf63036.hfx
host1# delete hf63037.hfx
host1# dir
Active System Controller:
-------------------------
reboot.hty
system.log
haIpSetup.mac
6-0-1p0-5.rel
6-1-0.rel
hf63035.hfx
host1# show hotfix detail
-----------
hf63035.hfx

Managing the Ethernet Port on the SRP Module

You can configure the Fast Ethernet management port to access the router from a
Telnet session or SNMP.
On ERX7xx models, ERX14xx models, and ERX310 router, the Fast Ethernet port
is located on the SRP I/O module. For more information about configuring the Fast
Ethernet port on an SRP I/O module, see ERX Hardware Guide, Chapter 7, Accessing
ERX Routers.
Use the Fast Ethernet port on the SRP I/O module only as a router management port.
Do not use this port to route traffic for Fast Ethernet or higher-level protocols such
as transport or routing protocols, because doing so affects the performance of the
router.
On the E120 and E320 routers, the Fast Ethernet port is located on the SRP IOA. For
more information about configuring the Fast Ethernet port on an SRP IOA, see E120
and E320 Hardware Guide, Chapter 7, Accessing E Series Routers.
interface fastEthernet
402
Managing the Ethernet Port on the SRP Module
first:
34563037
file
name active
------------
X
unshared
size size
--------- ---------
596288 596288
6762 6762
4874 4874
125987342 125987342
148489185 148412851
30445 30445
armed requires
----- --------
X ---
in
date (UTC) use
------------------- ---
03/07/2005 19:35:52
03/07/2005 17:30:08
03/24/2004 10:02:08
02/30/2005 18:17:32 !
02/28/2005 20:19:20
03/07/2005 14:04:02 !