Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 626

System basics configuration guide software for e series broadband services routers
Table of Contents

Advertisement

JUNOSe 11.1.x System Basics Configuration Guide
bandwidth oversubscription
configuring..........................................................376
monitoring..........................................................376
overview.............................................................373
bandwidth oversubscription command......................376
banner command......................................................285
banners
configuring..........................................................285
baseline commands
baseline show-delta-counts.................................337
baseline snmp....................................................239
BGP (Border Gateway Protocol)....................................24
blowfish-cbc encryption algorithm for SSH................437
boot commands
boot backup........................................................509
boot config..........................................................511
boot config factory-defaults.................................511
boot config once.................................................511
boot config running-configuration.......................511
boot config startup-configuration........................511
boot force-backup...............................................511
boot hotfix..........................................................392
boot revert-tolerance...........................................511
boot revert-tolerance never.................................511
boot subsystem...................................................511
boot system........................................................511
Boot mode.........................................................384, 387
accessing............................................................137
software installation............................................137
booting the system............................130, 135, 138, 509
rebooting............................................................514
while running scripts or macros..........................517
Border Gateway Protocol. See BGP
bottom-up approach to network configuration...............6
bridge commands
bridge subscriber-policy........................................88
broadcasts, NTP.........................................................530
bulk statistics, SNMP
collecting....................................................195, 237
configuring
collectors and receivers...............................195
schemas......................................................215
formatter............................................................237
if-stats objects.....................................................215
mapping to MIBs and CLI....................................223
monitoring
collection statistics.......................................200
schema statistics..........................................235
bulkstats commands..................................................200
bulkstats collector.......................................179, 200
bulkstats collector collect-mode..........................200
bulkstats collector description.............................200
bulkstats collector interval..................................200
bulkstats collector max-size................................200
bulkstats collector primary-receiver....................200
bulkstats collector secondary-receiver.................200
596
Index
bulkstats collector single-interval........................200
bulkstats file-format endOfLine-Lf.......................237
bulkstats interface-type.......................................200
bulkstats interfaces description-format
common.........................................................200
bulkstats receiver remote-name..........................200
bulkstats schema................................................215
bulkstats schema subtree....................................215
bulkstats schema subtree policy..........................215
bulkstats traps....................................................200
bulkstats virtual-router-group..............................200
See also show bulkstats commands
C
caching, configuration................................................517
capitalization. See case sensitivity
case sensitivity.............................................................67
channelized E1 interfaces
configuring............................................................15
channelized T1 interfaces
configuring............................................................14
channelized T3 interfaces
configuring............................................................12
line rates...............................................................10
characters on terminal screen, setting bits for............283
Classifier Group Configuration mode......................71, 91
clear commands
clear line.............................................................261
CLI (command-line interface).....................................255
abbreviating keywords....................................30, 67
accessing..............................................................48
command modes. See command modes
context-sensitive help...................................63, 255
editing keys..........................................................67
editing on.............................................................67
logging in..............................................................48
pausing...............................................................255
system prompts....................................................43
CLI access levels, VSA descriptions....................447, 448
CLI command execution by macro file.......................473
CLI messages
configuring..........................................................285
CLI status indicator......................................................43
client, SNMP..............................................................148
configuring access.......................................159, 160
clock..........................................................................525
clock commands........................................................525
clock set..............................................................525
clock summer-time date.....................................525
clock summer-time recurring..............................525
clock timezone....................................................525
cOCx/STMx interfaces
line rates...............................................................10
coldStart, SNMP trap..................................................168
Color Mark Profile Configuration mode..................71, 91

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.1

Table of Contents