Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 86

JUNOSe 11.1.x System Basics Configuration Guide
4
5
6
7
8
9
10
11
12
13
14
15
*Privilege Group can reach itself
Example 12 shows privilege group overrides in effect.
Example 13
host1#show privilege group 15 superUser
The following groups are directly reachable:
14
dailyAdmin
The following groups are reachable:
1
14
2
3
4
basicUser
dailyAdmin
dailyTroll
minUser
In Example 13, groups 14 and dailyAdmin are directly reachable and groups 1, 14,
2, 3, 4, basicUser, dailyAdmin, dailyTroll, and minUser are reachable.
privilege
56
CLI Command Privileges
--
basicUser
dailyTroll
weekendAdmin
--
--
dailyAdmin
--
--
LI
--
superUser
Use to change the privilege level of any command within a specified mode.
Example 1
host1(config)#privilege exec level 12 terminal width
Example 2
host1(config)#privilege exec all level 5 terminal
Use the all keyword to change the privilege level of groups of commands. For
more information, see "Setting Privilege Levels for Multiple Commands" on
page 59.
Use the reset version to restore the default privilege level for the command;
issuing this command results in the show configuration command not showing
the default privilege setting for the command.
Use the no version to restore the default privilege level for the command; issuing
this command results in the show configuration command showing the default
privilege level of the command in its output.
3 0 1 2 3
4 0 1 2 3 4
5 0 1 2 3 4 5
1 0 1
14 0 14
-- 0
6 0 1 2 3 4 5 6
5 0 1 2 3 4 5
5 0 1 2 3 4 5
10 0 1 2 3 4 5 6 10
-- 0
10 14 0 1 2 3 4 5 6 10 14 15