Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 355

exception gateway
exception protocol ftp
exception source
reload
Use the no version to disable the core dump.
See exception dump.
Use to specify the gateway through which the system sends the core dump file
to the FTP server.
Example
host1(config)#exception gateway 10.10.1.15
Use the no version to return the value to its default (null).
See exception gateway.
Use to set a username and password for FTP access to the server where you
transferred a core dump file. The default settings are the username anonymous
and no password.
Specify the number 8 before the username and before the password to encrypt
these values. By default, the username and password are not encrypted.
Example
host1(config)#exception protocol ftp 8 user_core 8 user_password
Use the no version to restore the default settings.
See exception protocol ftp.
Use to set the IP address and mask of the system interface over which you want
to send the core dump file to the FTP server.
You can optionally include an IP address mask.
Example
host1(config)#exception source 192.168.1.33 255.255.255.0
Use the no version to return the value to its default, null.
See exception source.
Use to reload the software on the router immediately.
Reloads the system software (.rel) file and the configuration (.cnf) file.
Reloading the standby SRP causes high availability to be temporarily disabled
until the standby SRP reloads and resynchronizes with the active SRP.
Example
host1#reload
Chapter 5: Managing the System
Troubleshooting the System
325