Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 95

exception
exclude-subsystem
exit
ftp-server
help
host
hostname
interface
ip
l2tp
license
line
log
macro
map-list
memory
mpls
no
ntp
policy-list
pppoe
profile
radius
rate-limit-profile
redundancy
route-map
router
rtr
run
service
set
sleep
slot
snmp-server
sscc
telnet
timing
traffic-shape-profile
virtual-router
Example 2 host1(config)#ip ?
address-pool
as-path
bgp-community
community-list
debounce-time
dhcp-local
dhcp-server
domain-lookup
domain-name
dvmrp
dynamic-interface-prefix
explicit-path
extcommunity-list
ftp
http
local
Configure core dump
Exclude copying a subsystem from the release
Exit from the current command mode
Configure FTP Server characteristics
Describe the interactive help system
Add/modify an entry to the host table
Set the host (system) name
Enter Interface Configuration mode
Configure IP characteristics
Configure L2TP parameters
Configure licenses
Enter Line Configuration mode
Configure logging settings
Run a CLI macro
Create an NBMA static map
Configure and administer memory operations
Configure MPLS global parameters
Negate a command or set its default(s)
Configure the Network Time Protocol
Enter Policy Configuration mode
Configure PPPoE
Specify a profile
Configure RADIUS server
Enter rate limit profile configuration mode
Perform a redundancy configuration
Configure a route map
Configure a routing protocol
Configure rtr parameters
Run an exec mode command (alias command do)
Configure system-level services
Configure
Make the Command Interface pause for a specified
duration
Configure and administer slot operation
Configure SNMP parameters
The SSC Client telnet
telnet daemon configuration
Configure network timing
Enter traffic shape profile configuration mode
Specify a virtual router
Configure address pool for PPP Broadband RAS
clients
Configure a path filter for AS-Paths in BGP
Format for BGP community
Configure an entry in a community list
Specify the minimum amount of time that an event
needs to be in same state before being reported
The DHCP Local Server protocol
DHCP Server for Proxy Client
Enable DNS lookup
Specify local Domain name
configure dvmrp paramaters
Specify name prefix for dynamic Ip shared
interfaces
Configure an explicit path
The extended community list
Configure FTP characteristics
Configure http server
Local IP address assignment
Chapter 2: Command-Line Interface
Using Help
65