Trap Categories - Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual

JUNOSe 11.1.x System Basics Configuration Guide
The maximum number of entries in the SNMP trap host table in each virtual router
is eight.

Trap Categories

The router supports the following trap categories:
168
Configuring Traps
SNMP format (v1 or v2) of the notification (trap) PDU to use for that destination
Types of traps enabled to be sent to that destination
Trap filters configured for the destination
addrPool Local address pool traps
atmPing E Series router proprietary ATM ping traps
bfdmib BFD MIB traps
bgp BGP state change traps
bulkstats Bulk statistics file full and nearly full traps
cliSecurityAlert Security alert traps
dhcp Dynamic Host Configuration Protocol traps
dismanEvent Distributed management (disman) event traps
dosProtectionPlatform DoS protection platform traps
dvmrp Distance Vector Multicast Routing Protocol traps
dvmrpProp E Series router proprietary DVMRP traps
environment Power, temperature, fan, and memory utilization traps
fileXfer File transfer status change traps
haRedundancy High availability and redundancy traps
inventory System inventory and status traps
ip Internet Protocol traps
ldp LDP traps
link SNMP linkUp and linkDown traps
log System log capacity traps
mobileIpv4 Mobile IPv4 traps
mplste Mplste traps
mrouter Mrouter traps
ntp E Series router proprietary traps
ospf Open Shortest Path First traps
packetMirror Packet mirroring traps; packet mirroring–related SNMP categories
and traps are visible only to authorized users. See JUNOSe Policy Management
Configuration Guide for information about using secure packet mirroring traps.
pim Protocol Independent Multicast traps