Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 251

5.
bulkstats schema
NOTE: If you create a collector but there is no schema for that collector, the collector
will not be active, and a schema will be created automatically for that collector to
collect if-stats for all subtree attributes.
bulkstats schema subtree if-stack
bulkstats schema subtree if-stats
host1(config)#bulkstats interface-type atm1483 collector 11
Configure a receiver to receive the collected statistics.
host1(config)#bulkstats receiver 11 remote-name qos.sts
See "Configuring Collectors and Receivers" on page 199 for information about
configuring collectors.
Use to create the schema for collecting bulk statistics.
Example Creates schema with schema index 4
host1(config)#bulkstats schema 4
Use the no version to delete the specified schema.
See bulkstats schema.
Use to retrieve interface and interface column configuration information.
Retrieves statistics from ifStackTable, which stores the configured interfaces and
their stacking relationship on a router.
Example Configures the if-stack schema
host1(config)#bulkstats schema 4 subtree if-stack
Use the no version to delete the specified schema.
See bulkstats schema subtree.
Use to retrieve interface usage data on sets of interface types.
To collect statistics for the specified counter type, use the subtreelist keyword.
To retrieve the offset from the master interval at which the record was created
for the bulk statistics interface record, use the time-offset keyword.
To collect the final statistics that may have been lost, use the
if-create-delete-time-stats keyword.
Example 1 Configures the schema to collect interface usage statistics for lower
interface
host1(config)#bulkstats schema 1 subtree if-stats subtreelist lower-interface
Chapter 4: Configuring SNMP
Collecting Bulk Statistics
221