Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 287

end
exit
Use to move from User Exec to Privileged Exec mode.
Privileged Exec mode allows you to access all other user interface modes. From
here you can configure, monitor, and manage all aspects of the router.
You can access the Privileged Exec commands using one of 16 levels of command
privilege. If you do not enter a privilege level and you are not accessing the router
through a RADIUS authentication account, the default CLI access level is 10. For
information about CLI levels of access, see "Privileged-Level Access" on page 49
in "Command-Line Interface" on page 29.
Set a password for this mode by using either the enable password or the enable
secret command in Global Configuration mode. This protects the system from
any unauthorized use.
Once a password is set, anyone trying to use Privileged Exec mode will be asked
to provide the password.
Example 1 (accessing Privileged Exec mode at the default level 10)
host1>enable
password:*******
host1#
Example 2 (accessing Privileged Exec mode at the highest level 15; a password
is not set for this example)
host1>enable 15
host1#
There is no no version.
See enable.
Use to exit Global Configuration mode or any of the other Configuration modes.
You may also use Ctrl+z to exit these modes.
Executing this command returns you to the User Exec mode.
Example
host1(config)#end
host1#
There is no no version.
See end.
Use to exit the current command mode or the system when issued from the
User Exec mode.
Example
host1#exit
host1>
Chapter 5: Managing the System
257
Using the CLI