Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 260

JUNOSe 11.1.x System Basics Configuration Guide
Table 29: Mapping Bulkstats Output to MIB Flies and CLI Configurations for Policy Schema (continued)
Bulkstats Output
Column Name MIB File
ifHCOutMulticastPkts RFC2863
ifHCOutBroadcastPkts RFC2863
ifHCInMulticastOctets -
ifHCOutMulticastOctets -
Table 30 on page 231 shows the mapping between the bulkstats output and the CLI
and MIBs for QoS schema.
230
Collecting Bulk Statistics
MIB Object Name CLI Configuration
ifHCOutMulticastPkts out-mcast-pkts
ifHCOutBroadcastPkts out-bcast-pkts
- in-mcast-octets
- out-mcast-octets
Description
The total number of packets
that higher-level protocols
requested be transmitted,
and which were addressed
to a multicast address at
this sub-layer, including
those that were discarded
or not sent. For a MAC layer
protocol, this includes both
Group and Functional
addresses. This object is a
64-bit version of
ifOutMulticastPkts
Discontinuities in the value
of this counter can occur at
re-initialization of the
management system, and
at other times as indicated
by the value of
ifCounterDiscontinuityTime
The total number of packets
that higher-level protocols
requested be transmitted,
and which were addressed
to a broadcast address at
this sub-layer, including
those that were discarded
or not sent. This object is a
64-bit version of
ifOutBroadcastPkts
Discontinuities in the value
of this counter can occur at
re-initialization of the
management system, and
at other times as indicated
by the value of
ifCounterDiscontinuityTime
Multicast octets received
Multicast octets sent