Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 101

Table 10: Command Mode Overview (continued)
Mode Name Use of Mode
Classifier Group
Configuration
Color Mark Profile
Configuration
Control Plane
Configuration
Controller Configuration
DHCP
Local Pool Configuration
Access to Mode
Configure classifier
groups with policy
rules used for policy
lists.
host1(config-policy-list-
classifier-group)#
Configure packet color
after exit from
rate-limit hierarchy.
host1(config-color-mark-
profile)#
Configure SRP module
policing.
host1(config-control-plane)#
Configure physix`cal
interfaces (for
example, T3).
host1(config-controll)#
Configure DHCP local
pools.
host1(config-dhcp-local)#
Chapter 2: Command-Line Interface
Exit from Mode
To create a classifier
group, from Policy List
Configuration mode use
the classifier-group
command and identify
the CLACL and
precedence.
Prompt:
From Rate Limit Profile
Configuration Mode,
use the
color-mark-profile
command and identify
the interface type (IP,
IPv6, MPLS).
Prompt:
From Global
Configuration Mode,
use the control-plane
command.
Prompt:
From Global
Configuration mode,
use the controller
command.
Prompt:
From Global
Configuration mode,
use the ip dhcp-local
pool command.
Prompt:
Accessing Command Modes
Use the exit command twice to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
71