Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 111

Table 10: Command Mode Overview (continued)
Mode Name Use of Mode
RADIUS Configuration
RADIUS Relay
Configuration
Rate Limit
Profile Configuration
Redundancy
Configuration
Remote Neighbor
Configuration
Access to Mode
Configure Broadband
Remote Access Server
(B-RAS) parameters.
host1(config-radius)#
Configure RADIUS
relay server
parameters.
host1(config-radius-relay)#
Configure an IP or
L2TP rate limit
parameters.
host1(config-rate-limit-
profile)#
Configure high
availability (stateful
SRP switchover).
host1(config-redundancy)#
Configure remote
neighbor parameters
for OSPF, PIM, or RIP.
host1(config-router-rn)#
Chapter 2: Command-Line Interface
Exit from Mode
From Global
Configuration mode,
use the radius server
command.
Prompt:
From Global
Configuration mode,
use the radius relay
server command.
Prompt:
To create an IP rate
limit profile, from
Global Configuration
mode use the ip
rate-limit-profile
command.
To create an L2TP rate
limit profile, from
Global Configuration
mode use the l2tp
rate-limit-profile
command.
Prompt:
From Global
Configuration mode,
use the redundancy
command.
Prompt:
From Router
Configuration mode,
use the
remote-neighbor
command.
Prompt:
Accessing Command Modes
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command once to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
Use the exit command twice to
return to Global Configuration
mode.
Press Ctrl+z to return to Exec
mode.
81