Managing Vty Lines - Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual

System basics configuration guide software for e series broadband services routers
Table of Contents

Advertisement

JUNOSe 11.1.x System Basics Configuration Guide
help
run
sleep

Managing vty Lines

The system supports 30 virtual tty (vty) lines for Telnet, SSH, and FTP services. Each
Telnet, SSH, or FTP session requires one vty line. When you connect to the router
through a vty line, the number of the vty line is not assigned sequentially; instead,
the system assigns the first vty line that passes the host access list check rules.
258
Managing vty Lines
There is no no version.
See exit.
Use to display basic information about the interactive help system.
Example
host1#help
Use the help options as follows:
?, or command<Space>? - Lists the set of all valid next keywords or
arguments
partial-keyword?
- Lists the keywords that begin with a certain
character string
partial-keyword<Tab> - Completes the partial keyword
There is no no version.
See help.
Use to issue an Exec mode command from any CLI configuration command
mode.
Example
host1(config)#run show configuration | begin interface
The run command functions the same as the do command.
There is no no version.
See run.
Use to make the CLI pause for a specified period of time (in seconds).
Pausing is very useful in configuration script files.
Example
host1#sleep 60
There is no no version.
See sleep.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.1

Table of Contents