Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual page 300

JUNOSe 11.1.x System Basics Configuration Guide
!
! End of generated configuration script.
Example using interface keyword:
host1# show configuration interface serial 4/0
interface atm 4/0
atm vc-per-vp 1024
atm uni-version 3.0
!
interface atm 4/0.1 point-to-point
profile pppoe myProfile
qos-profile myQosProfile
!
interface atm 4/0.2 point-to-point
qos-profile myQosProfile
ip description TestIP
!
interface atm 4/0.3 point-to-point
Example using category keyword:
host1# show configuration category system file-system
boot config running-configuration
boot system m.rel
no boot backup
no boot subsystem
no boot backup subsystem
show running-configuration
tag-group
270
Monitoring the Current Configuration
See show configuration.
Use to display the configuration currently running on the router, a specified
virtual router, a specified interface, or a specified category of router settings.
Example
host1#show running-configuration
Example 2
host1#show running-configuration interface serial 4/0
Example 3
host1#show running-configuration category system file-system
See show running-configuration.
Use to configure an interface tag group.
Any number of interfaces can be in a tag group.
Interface types tunnel, lag, mlppp, and mlframe-relay cannot be added to tag
groups.