Monitoring The Nfs Client - Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual

System basics configuration guide software for e series broadband services routers
Table of Contents

Advertisement

ip nfs host

Monitoring the NFS Client

Use "show hosts" on page 343 command (see "Monitoring the System" on page 337)
to monitor information about connected NFS servers. Use "show ip nfs" on page 317
command to display information about the interface that the current virtual router
uses to exchange messages with the NFS server.
show ip nfs
Use to specify the E Series interface that the current virtual router will use to
exchange messages with the NFS server.
Specify either the source-address keyword with the IP address of the interface
or the source-interface keyword with the interface type and specifier. For
information about interface types and specifiers, see Interface Types and
Specifiers in JUNOSe Command Reference Guide.
Issuing this command provides connectivity between the E Series router and the
remote host if the network configuration restricts communications between
devices.
Example
host1:boston(config)#ip nfs source-address 10.1.1.1
host1:boston(config)#ip nfs source-interface atm 3/2.6
Use the no version to delete the name server.
See ip nfs.
Use to configure a remote host as an NFS server for the current virtual router.
Optionally, specify a user identity and a group identity that a user must specify
to connect to the remote host. The default user identity is 2001, and the default
group identity is 100.
Example
host1:boston(config)#ip nfs host host50 user 1500 group 150
Use the no version to disassociate this NFS server from the current virtual router.
See ip nfs host.
Use to display information about the interface that the current virtual router uses
to exchange messages with the NFS server.
Field descriptions
Source address IP address of the interface that the current virtual router
uses to exchange messages with the NFS server.
Source interface Type and specifier of the interface that the current virtual
router uses to exchange messages with the NFS server. For information
about interface types and specifiers, see Interface Types and Specifiers in
JUNOSe Command Reference Guide.
Chapter 5: Managing the System
Configuring the NFS Client
317

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.1

Table of Contents